Skip to content

Compare

Which solution
suits the roof build-up?

The same questions for each line: where the layer sits, what goes on top, how it is installed and which evidence belongs to it.

VlamShieldSHEET

Material principle: Cement-bound glass-fibre composite
Position: Beneath the new membrane
Typical project: Mineral intermediate layer with low build-up height
Installation: Board concept with factory curing
Indicative mass: 10 kg/m² at 10 mm
Key comparison points: Heat transfer, joints and build-up height

VlamShieldVLOEI

Material principle: Cement-bound mineral roof coating
Position: On the existing roof membrane
Typical project: Adapted mineral surface layer on an existing roof
Installation: Mix, squeegee or trowel, cure
Indicative mass: Depends on the version and layer thickness
Key comparison points: Adhesion, movement and work sequence

VlamShieldWEER

Material principle: Weather-resistant cement-bound mineral board
Position: Above waterproofing, directly beneath PV
Typical project: PV roof with waterproofing worth retaining
Installation: Lay, coordinate contact and provide wind restraint
Indicative mass: Approx. 12 kg/m² at 15 mm
Key comparison points: Supports, weather, drainage and wind

Compare BarrierSheet and SHEET →

Applications

From situation to product line

A new membrane allows different installation positions from one that stays in place. Compare these two construction routes first.

Which protective layer suits your roof?

VlamShield SHEET: Cement-bound glass-fibre board beneath roof waterproofing

VlamShield SHEETCement-bound glass-fibre board beneath roof waterproofingBeneath a new roof membrane

VlamShield VLOEI: Cement-bound protective layer for existing PV roofs

VlamShield VLOEICement-bound protective layer for existing PV roofsOn the existing roof membrane

VlamShield WEER: Weather-resistant mineral board above waterproofing beneath PV

VlamShield WEERWeather-resistant mineral board above waterproofing beneath PVOn the roof surface, above the waterproofing

Project enquiry

Send your roof build-up. Discuss the material choice.

A few photos and the roof area are enough to start. You receive a project proposal with the specific configuration, the supporting documentation and the open points we agree with you.

Start a project enquiry

Or directlyinfo@vlamshield.nl